In a typical nanopore-sensing experiment, ions and biomolecules a

In a typical nanopore-sensing experiment, ions and biomolecules are driven by an external transmembrane electric field. Biomolecule passage through the nanopore can cause a characteristic temporary blockade SB431542 concentration in the trans-pore ionic current. Information of the biomolecules

such as length, composition, and interactions with other biomolecules can be extracted from the blockade ionic current. In order to get the structural information of a DNA strand at the single base level, a bottleneck to break through is to control the DNA GSK2126458 cell line translocation speed through a nanopore. Intuitively, we can change the applied voltage, salt concentration, viscosity, and electrolyte temperature to reduce the translocation speed [10]. The side effect of this method is the reduction of the signal amplitude, which leads to more difficulties in capturing the very weak ionic current change [11]. Another method is to apply a salt gradient on the electrolyte solution across the pore, which can be used not only to prolong the translocation time but also to enhance the capture

rate [12]. Recently, some groups tried buy SRT1720 introducing positive charges into nanopores as molecular ‘brakes’, which is proved to be an effective approach to increase the attractive force between the negative DNA molecule and the positive nanopore inner wall, thus increasing the duration time more than 2 orders of magnitude [13]. The shortcoming of this method is that the residual ionic current during the DNA translocation is insufficient for direct base identification. Aside from an electric field applied along the nanopore axis direction, Tsutsui et al. added a transverse

electric field to slow down the translocation speed of DNA across the nanopore [14]. It is reported that adding a transverse field of 10 mV/nm in a gold electrode embedded silicon dioxide channel can filipin make 400-fold decrease in the DNA translocation speed. Similarly, He et al. reported a method to control the DNA translocation speed by gate modulation of the nanopore wall surface charges. It is found that native surface-charge-induced counterions in the electro-osmotic layer substantially enhance advection flow of fluid, which exerts stronger dragging forces on translocating DNA and thereby lowering the DNA translocation speed. Based on this phenomenon, they regulate DNA translocation by modulating the effective wall surface charge density through lateral gate voltages. The DNA translocation speed can be reduced at a rate of about 55 μm/s per 1 mV/nm through this method [15, 16]. Yen et al. [17] and Ai et al. [18] reported that applying positive gate voltage could also induce DNA-nanopore electrostatic interaction, which can regulate the DNA translocation speed.

Comments are closed.