7%), which was heated at 350°C for 30 min. The dye-coated electrode and Pt counter electrode were separated with a hot melt plastic frame (Solaronix, Meltonix 1170, 60-μm thick)

at pressure of 2.5 bar and temperature of about 105°C. The electrolyte (0.1 M LiI, 0.03 M I2, 0.5 M tetrabutylammonium iodide, and 0.5 M 4-tert-butylpyridine in acetonitrile) was introduced into the gap formed by two electrodes. The holes were then sealed using hot-melt plastic and a thin glass cover slide. The LY3039478 DSSC active area was 0.15 cm2. The surface and cross-sectional images of ZnO nanostructures were characterized using a field emission scanning electron microscope (FE-SEM, Hitachi S4700, Chiyoda-ku, Japan). The microstructure of ZnO nanorods and microflowers was measured by transmission electron microscopy (TEM) and high-resolution TEM (HRTEM) together with Thiazovivin datasheet selected-area electron diffraction (SAED). The X-ray diffractometer

(XRD) was used to evaluate the phase of products. Photocurrent-voltage (J-V) was measured by using a Keithley 2400 source/meter controlled by a PC, while irradiating at 100 mW · cm−2 (1 sun) with AM 1.5G simulated sunlight produced by a class 3A solar simulator (Newport, 94043A, Irvine, CA, USA). Incident photon-to-electron conversion efficiency (IPCE) was measured as a function of wavelength from 400 to 800 nm under short circuit conditions (Newport, IQE-200). Both the absorption spectrum of the dye and diffuse reflectance spectrum of nanostructures were characterized by a UV-vis spectrophotometer (Shimadzu UV-3600, Kyoto, Japan). The electrochemical impedance spectroscopy (EIS) was measured by an Autolab

electrochemical workstation (PGSTAT 302 N) under the open circuit (V oc) condition in dark. The magnitude of the alternative signal was 10 mV. Results and discussion Figure 1 shows the representative SEM images of ZnO nanostructures synthesized at different reaction times from 30 min to 5 h. When the reaction time was 30 min, the vertically oriented nanorod array with an average length of 1.5 μm and a diameter of 80 nm was obtained (Figure 1a,b). After 40 min of reaction, the basic morphology of array was preserved, but the close examination revealed Reverse transcriptase that a central hole lay on every top plane of the nanorods (Figure 1c,d). This implies that a dissolution process may occur during the growth. As the reaction time was prolonged to 1.5 h, the sample was composed of microflowers on the top and a nanorod array underneath (Figure 1e,f). With increasing the reaction time to 3 h, multilayers of microflowers were formed, which makes the nanorod array invisible (Figure 1g,h). Further extending the reaction time to 5 h, unexpectedly, the microflowers almost completely disappeared and large etched pits on the surface appeared, and even the length of nanorods was reduced significantly to about 300 nm (Figure 1i,j). Vistusertib cost Figure 1 Top view and cross-sectional SEM images of ZnO nanostructures synthesized at different reaction times.